cable length
英 [ˈkeɪbl leŋθ]
美 [ˈkeɪbl leŋθ]
链（英国608英尺，美国720英尺）；电缆长度；线长；电线长度
英英释义
noun
- a nautical unit of depth
双语例句
- The propagation process of pulse wave in the cable and influence of cable length on overvoltage and wavefront time of winding are discussed in this paper.
讨论了脉冲波在电缆中的传播过程以及电缆长度对线圈端的过电压和脉冲上升时间的影响。 - According to the mechanic characteristics of this system, the bearing cable, the stress-free cable length of carry cable and the meticulous algorithm of suspension force of each span are given, and the influence of gentle cable elongation on its dead weight is presented.
文中根据该系统的力学特点，给出了承重索、轨索的无应力索长和各跨吊杆力的精细算法，并计入了柔索伸长对其自重集度的影响。 - The basic theory of control method of unstressed cable length is illustrated. And this control method is employed for adjustment hanger force of self-anchored suspension bridge, order to conform with require of design.
阐述了无应力索长控制法的基本理论，并采用该控制方法调整自锚式悬索桥吊杆的内力值，使之符合设计要求。 - In the oil and gas field development process, the well depth measured by measuring the length of running cable, but the current cable length measurement mainly by motor and Martin Dyke wellhead two measurement methods.
油气田开发过程中的井深测量是通过测电缆运行长度来实现的，而目前对电缆长度计量主要有井口马达和马丁代克两种计量方式。 - Place the units in their intended mounting locations to check the cable length and monitor installation conditions.
把设备放入计划好的安装位置，检查电缆长度和监视器安装条件。 - The results of simulation and engineering applications indicate that the wavelet de-noising processing with the decomposition level determined by the adaptive selection algorithm can effectively filter out the noise from the TDR signal and then improve the measuring accuracy of the TDR cable length measurement system.
仿真结果和工程应用结果表明，采用该方法确定的小波分解层数对被测信号进行消噪处理，可以有效的滤除信号中的噪声，提高时域反射电缆测长系统的测量精度。 - It is important for the cable length to be suitable for the depth of the hole concerned.
脚线的长度要适应于炮眼的深度，这一点是很重要的。 - Meanwhile, a decision method for determine an unknown cable length also recommend.
同时本文还向大家介绍一下未知电缆长度的电缆长度的简易判定方法。 - In case the welding machine cannot be placed close to the welding area, enough cable length for both, the welding cable as well as the earth clamp has to be provided.
如果焊机不能置于靠近焊接区，必须提供足够长度的焊接线以及接地夹。 - The principle error of the TDR cable length measurement has also been analyzed. The influence of measuring numbers, counting pulse frequency and traveling wave velocity on measuring accuracy is analyzed.
分析了时域反射电缆测长的原理误差，研究了测量次数、计数脉冲频率、行波波速对测量精度的影响。